Scantronic 4603 Instrukcja Instalacji Strona 28
- Strona / 34
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
28 of 34 496372 Issue 1
Testing
Figure 20. 4608 Jumpers
Zone Locator Test
To perform a zone locator test, fit the 'OZW' link in the 'Z' position. This will
illuminate the red LED.
With the transmitter board removed, loosen the centre retaining screw and
locate the rear pcb in the uppermost position, then refit the battery and front
lens cover. Move around within the protected area and observe the PIR lens.
Where you can see a bright red light within a lens segment, the PIR is detect-
ing that area. Confirm the coverage as required for other areas. When
complete, ensure the main pcb is in the bottom position.
Walk Test
To perform an engineer walk test of the PIR, fit the 'OZW' link in the 'W'
position.
Replace the transmitter board, refit the battery and front lens cover. Continue
to move around the protected area until the PIR LED illuminates. Following a
short delay, the transmitter will transmit to the receiver/control panel. Confirm
walk testing for the protected area as required.
Normal Operation
To finally set the PIR for normal operation, fit the 'OZW' in the 'O' position.
Replace the transmitter board, refit the battery and the front cover. The PIR
will then take approximately two minutes to stabilise. During normal opera-
tion, the PIR will detect an intrusion, transmit a signal, then shut down for 2.5
minutes. If no subsequent movement is detected within the 2.5 minutes, the
PIR will reset ready to activate again. If movement occurs before the two
minute time window, a further two minutes will be added.
Note: The 'OZW' positions may differ on some PIRs. Always follow the positions
shown on the main pcb.
In normal use, the link must be in the 0 position otherwise the battery life will
be reduced by over 90%.
4608
- 4601/4602/4603/4604/4605/ 1
- 4606/4608/4609/4624 1
- Reference Guide 1
- Battery Life 2
- 4600 Panel 4
- 496372 Issue 1 5 of 34 5
- Re-assembly 6
- 8 of 34 496372 Issue 1 8
- Physical Layout 10
- Controls 11
- Technical Specification 12
- Programming 12
- Both Channels (Door Contact) 13
- Other Checks 14
- Introduction 14
- Final Commissioning 14
- Coding The Transmitter 15
- 4611/4613 16
- Switching On 16
- 496372 Issue 1 21 of 34 21
- PIR PCB Layout 23
- Figure 16. 4608 PB Layout 24
- Lens Changing and Patterns 25
- CODING THE TRANSMITTER 26
- 496372 Issue 1 27 of 34 27
- Zone Locator Test 28
- Walk Test 28
- Normal Operation 28
- Coding the Transmitter 29
- Technical Specifications 31
- Setting Up Modes 32
- 4618/9 only 32
- 4612 only 32
- Low Battery (Power) Reporting 33
- 34 of 34 496372 Issue 1 34
Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Scantronic 4603
(30 strony)Panasonic DVDLS55EG manuales
Manuales del propietario y guías del usuario para Audio Panasonic DVDLS55EG.
Ofrecemos 1 manuales en pdf Panasonic DVDLS55EG para descargar gratis por tipos de documentos: Manual de usuario
Komentarze do niniejszej Instrukcji