Scantronic 9800+ Instrukcja Użytkownika Pobierz pdf (Strona 11)

The user can set or part set the system with selected alarm zones omitted

from the system. (If zone is programmed by engineer for ‘Omit Enabled’.)

However certain zones, classified as ‘Non Omit’ cannot be omitted. To set

the system with zone(s) omitted, proceed as follows:

(e) Repeat step (c) for other zones to be omitted. The system will set as

normal. Omit LED will extinguish when system sets.

Press ‘Omit’ key within 5

seconds, followed by zone

number(s) to be omitted.

To re-instate an omitted zone,

press the ‘Omit’ key followed by

the ‘Clear’ key. All circuits

omitted are re-instated when the

system is unset.

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

Enter access code. Select ‘A’ for whole system, or

‘B’ or ‘C’ for part setting.

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

(a) (b)

Setting With Zones Omitted

- -

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Komentarze do niniejszej Instrukcji

Brak uwag

Scantronic 9800+ Instrukcja Użytkownika Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Scantronic 9800+