Scantronic 8136 Podręcznik Użytkownika Pobierz pdf (Strona 29)

496339 Issue 1 29 of 44

To make sure this facility works correctly the installer must program the

system using Menu 73 as follows:

1. Make sure Secure Callback is disabled.

2 Enter the telephone number of the downloading PC.

The user starts a call out from Menu 5 "Answer remote call from cs". When

the keypad displays the words "WAITING FOR RINGING" the user must

press keys 4 and 6 together. The end station then makes one attempt to

establish a call with the remote PC.

Note: The downloading PC must have the account details already set up to accept

the call.

Fault Finding

General Faults

No response from the keypad keys.

• Check the keypad wiring.

• Check the keypad address programming. See "Keypads".

• Enter and leave programming mode.

• Power up while shorting RST pins. (See "Resetting User and Installer

Codes".)

No exit/entry tones from remote keypad

• Check keypad is addressed correctly. See "Keypads".

• Check that Keypad Sounder is ‘Enabled’. See "Keypads".

• Check keypad is assigned to the Level being set (Menu 47).

• Check if keypad faulty.

Manual Connect from the remote PC fails to operate.

• Check Secure Call Back is ‘Disabled’ (menu 73).

Cannot remotely Set/Unset system

• Check Remote Set/Unset ‘Enabled’. Refer to user Menu 3 - ‘System

Options’. (Note that the Installer Code does not allow you access to

User Menu 3.)

8136 Fault Finding

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Brak uwag

Scantronic 8136 Podręcznik Użytkownika Strona 29